Storing & Transfer of Remote BD_ADDRs
Original Post: who will store the BD_ADDR (eGroups Msg. ) Date:
2000-09-20
When a Bluetooth units want to bypass a inquiry scan,and go straight
into paging a remote device, then it MUST know the BD_ADDR of that
particular device.
This remote BD_ADDR is stored in the host (HCI Layer) , where it was
originally stored via the HCI Inquiry Result Event. When the host wishes
to setup a connection (page) the remote BD_ADDR Then it passes the BD_ADDR
to the lower levels via the HCI link command Create Connection, in exactly
the same way that it would after an Inquiry operation.
However this means the (potential) master will probably not know the
(potential) slave's clock offset. This information can only be obtained by
an "Inquiry" or after the connection is made.
|
